Barco Coronis Elite Spezifikationen PDF herunterladen (Seite 52)

Connecting the signal cables

To connect the signal cables to the display:

1. Make sure the computer is turned off.

2. To get access to the connectors, remove the connector

compartment cover (1).

To remove the cover, gently pull the bottom side of the cover

upward or firmly press down the 2 clips at the top side

(positions marked in the plastic).

3. To facilitate cable routing afterwards, remove the tilt & swivel

neck cover (2). Therefore, first tilt the display panel in upright

position. Then lift and pull backward the neck cover.

4. Also to facilitate cable routing afterwards, open both cable duct

covers (3).

Figure 25: Remove covers before connecting signal cables

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 99 100

Keine Kommentare

Barco Coronis Elite Spezifikationen Seite 52