Barco BlendPRO-II Bedienerhandbuch PDF herunterladen (Seite 118)

118 ScreenPRO-II Controller • User’s Guide

4. Menu Orientation

System Menu

• SP to Add — (as you rotate the ADJ knob), lists all available ScreenPRO-II units

that can be assigned to the selected destination.

Units are identified by their ID

number.

If a ScreenPRO-II is currently assigned to another destination, it will not

appear in the list.

• SP to Remove — lists all assigned ScreenPRO-II units that can be removed from

the selected destination.

Units are identified by their ID number.

• Routing Mode — enables you to set the ScreenPRO-II’s routing mode — either

Internal or External. This function instructs the system how sources are used on

the assigned ScreenPRO-II unit(s).

• At the bottom of the menu, the Status section dynamically lists the ScreenPRO-II

IDs assigned to the current destination.

• Press {ADD} to add the selected ScreenPRO-II (on the SP to Add line) to the

current destination configuration.

• Press {REMOVE} to remove the selected ScreenPRO-II (on the SP to Remove

line) from the current destination configuration.

• Press {BACK} to return to the System Menu.

Important

If you have configured a widescreen destination, the moment

you press

{BACK}, the system automatically checks the

termination status of each ScreenPRO-II.

• If the termination switch is properly set on each

ScreenPRO-II, no action is required.

• If any termination switch is improperly set, the

ScreenPRO-II Genlock Termination Menu appears,

with instructions on how to correct the problem.

Refer to the “

ScreenPRO-II Genlock Termination Menu”

section on page 119 for details.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 291 292

Keine Kommentare

Barco BlendPRO-II Bedienerhandbuch Seite 118