Barco Coronis 3MP Bedienungsanleitung PDF herunterladen (Seite 17)

System manual Coronis 3MP 18

hctiwS noitcnuF

NEAGV.)NOsitluafed(daeHyramirPehtnoAGVselbanE

NESOIBSOIBOEDIVehtdaerotSOIBmetsySehtswollA

.)NOsitluafed(

LAMRON.)NOsitluafed(etatSdraoBslortnoC

KLCTNI.)NOsitluafed(kcolClanretnI

etihwehtnehwnoitisopNOehtnierasehctiwsehT

ehtfopotehtsdrawotdenoitisopsihctiwsredils

.draob

Using the VGA Capabilities of the BarcoMed 3MP2FH,

2MP2FH or 1MP2FH

Prior to installing the BarcoMed 3MP2FH, 2MP2FH or 1MP2FH,

decide if you are going to use its on-board VGA capabilities.

If you are, check the setting of the VGA switches on the graphics

board. (See S1- VGA switches, figure 1.) By default, VGA should be

enabled.

If you decide to use a separate VGA monitor as your boot monitor,

you must disable the on-board VGA capabilities of the BarcoMed

3MP2FH, 2MP2FH or 1MP2FH by setting switches #1 and #2 on the

3MP2FH, 2MP2FH or 1MP2FH display controller to the “off” position.

The two switches are labeled “VGA EN” and “BIOS EN” respectively.

Use a pen or small flat bladed screwdriver and move the white slider

switch toward the bottom of the switch (towards the numbers).

NOTE: To use multiple 3MP2FH, 2MP2FH or 1MP2FHs in a single

host with VGA enabled, you need to enable VGA on only ONE of the

3MP2FH, 2MP2FH or 1MP2FHs and disable VGA on ALL other

BarcoMed display controllers.

Examples of PCI Slots

Although the BarcoMed 3MP2FH, 2MP2FH or 1MP2FH has a 64 bit

PCI connector, it functions as a 32 bit board. It may be installed in

either a 32 bit or 64 bit slot with no loss of functionality. Figure 2

illustrates the types of slots so that you can correctly identify which

one to use for the 3MP2FH, 2MP2FH or 1MP2FH.

Imaging board installation

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 98 99

Keine Kommentare

Barco Coronis 3MP Bedienungsanleitung Seite 17